U1434 Lamborghini Auto Trouble Code

U1434 Lamborghini Auto Trouble Code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

The computer notices the canister is empty when it detects a leaner condition (all the vapors are used up) and it resumes normal fuel delivery. Some car manufacturers then close the vent solenoid but leave the purge solenoid open. That creates a vacuum throughout the entire fuel storage system. Once the correct vacuum is reached, it closed the purge solenoid and waits to see if the vacuum holds.

U1434 Lamborghini Possible Solution:

Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.

U1434 Lamborghini Description For All Models :

U1434 Lamborghini Trouble Repair :

The sensors receive a 5 volt reference signal from the PCM. As pressure readings change, the sensor varies the voltage and the computer reads that to determine input. In the case of a broken wire, the sensor never sees the voltage and the computer assumes a major fault. So if you get this U1434 Lamborghini code, first check to make sure you're getting a good 5 volt reference signal at the sensor.

Code Search

Please fill the search bar to find Auto Trouble Code meaning.

Example: 0120